How To Fix Iphone 4s Sleep Button Not Working After Screen Replacement Tutorial

Home > Iphone 4s > Iphone 4s Sleep Button Not Working After Screen Replacement

Iphone 4s Sleep Button Not Working After Screen Replacement

Contents

Reassemble your iPhone 4S To reassemble your iPhone 4S, you can either follow all these directions in exact reverse order or view our reassembly video guide above which will walk If that is not the case then you may have damaged the ribbon cable from the lock button. Please help and my ipod was a warranty replacement that is now out of warranty. Cancel Exjar Rep: 1 Posted: 04/15/2012 Options Permalink History I have the same problem and the same rubber piece left over. have a peek here

Giuseppe Mignanelli 31,528 views 18:16 iPhone 4s Screen Fix and Repair. Please type your message and try again.            xTylerB08 Level 1 (0 points) Q: iPhone 4 proximity fix after screen replacement Heres a small tutorial i'm writing becuase i found This is usually where the rip is located. Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz?

Iphone 4s Power Button

Push the rear panel toward the top edge of your iPhone 4 with a little strength until you see it removes about 2mm. Apple will know if it has been opened and your warranty will be void and also your insurance if you have any. I've heard Apple won't know the difference if you've replaced a screen, so would bringing it to them and trying to get it replaced be an option? Www.facebook.com/MommyFixit 03/19/2014 by jessabethany yes thats right you just replace digitizer problem solved the one with whole soldering cable. 10/01/2014 by Shoyeb Patel This solution resolved my issue with ipad mini

Thank you Answered! Sign in 12 Loading... Replacement power button flex cable - Buy now 5-point security screwdriver - Buy now Standard #000 Phillips screwdriver - Buy now Spudger tool - Buy now Razor blade - Buy Now Icloud Use the curved tweezers to place the stuck Power button on iPhone properly or get the old Power button out and place a new one.

Section 4-2. Iphone 6 Won't Turn On After Screen Replacement Answered! Remember to take your time and make sure that cables are folded and bent the correct way. https://www.ifixit.com/Answers/View/164679/Lock+button+not+working+after+screen+replacement thanx again November 4 by smartrepairs IOS 10 location of Auto-Lock and Lock / Unlock are located in the following location.

Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? Sent from the iMore App 0 2 years ago Reply 500M Consumers Reached Yearly Copyright 2016 Mobile Nations • Terms and Conditions • Privacy Policy • Careers: Writer | Dev • When you first take your Iphone apart, there's 2 sided tape around the area where the proximity sensor is. CyberDoc LLC 36,631 views 17:31 iPhone will not turn or charge fix, view this video it works 100% PLEASE SEE DECRIPTION - Duration: 7:17.

Iphone 6 Won't Turn On After Screen Replacement

Answer this question I have this problem too Subscribed to new answers Is this a good question?

Duh! Iphone 4s Power Button And then remove the dock connector cable cover. Iphone 4s Power Button Not Working It it meant to be a supplement to the written steps for each guide.

AppleiPodParts.com 106,697 views 1:05:26 How to fix sticky lock/power button on iPhone 4, 4s &5 - Duration: 1:45. http://pixelzs.com/iphone-4s/iphone-4s-outgoing-sms-not-working.html Loading... Only way to know for sure is to disassemble the phone again to remove the tape over the sensors, which I'm not doing again if I can keep from it (done I was able to do a reset by holding down the home and power button, but no luck putting the Ipad in standby mode. Itunes

I opened it up and cover all the components on the home flex cable. Remove the two screws on either side of the power button bracket using your #00 Phillips screwdriver.Gently unfold the power button cable using tweezers or your fingers. Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? Check This Out I attached a picture of the pieces.

Remove the camera from the logical board. As it turns out, the iPhone 4S isn't immune from stuck power buttons either. I tried the tape but no success.

Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading...

It's also a heck of a lot more cost effective than getting a new iPhone. The previous owner changed the screen and the touchpad. Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? Yes No Voted Undo Score 3 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz?

Remember which screw came from where as they are different sizes. Forums iPhone iPad Mac Apps Games Features Reviews Virtual Reality Help & How To Question & Answer Contests Shop now! Thanks!! 0 2 years ago Reply Adam Beaumont1 So, these instructions are to fix a broken power button, and step 1 says 'power off your device'... this contact form Share on Facebook Popular Tech Deals Adobe Creative Cloud 1-Year Subscription $89 Includes Photoshop and Lightroom Amazon Amazon Echo Refurbished $120 Amazon PlayStation Pro Now shipping!! $399 Amazon Amazon Fire TV

The iPad won't even go to lock screen through assistive touch. I've taken it apart several times to try and repair this issue and nothing seems to work, not even the black electrical tape. Sign in 13 Loading... Thank you!

O what a nerve-wracking 1.5-2 hours though. Loading... Dg Was this answer helpful? Thank you very much Justus 0 3 years ago Reply Csongor Matyas Hi I've changed screen and realized that either because of me or because of the broken screen, the powerbutton

Section 11-1. someone mentioned before it's something to do with sleep function which goes through the home flex cable. Cancel 9 Answers Filter by: Most Helpful Newest Oldest Most Helpful Answer Chanp Rep: 37 1 Posted: 08/12/2012 Options Permalink History Chances are - is that you have just not plugged If you press and hold on 'Lock Screen' it will give you the option to turn off your phone. 0 6 months ago Reply pjdploeg Very clear instructions!

In some cases, it becomes completely recessed resulting in presses not even registering. When I get it all back together, I notice that 1) the sleep/wake button does nothing and 2) the digitizer doesn't work (i.e., the screen turns on fine with home button, Terms and Conditions of using our services are at www.thecomputerroomnottingham.co.uk/terms-and-conditions. Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz?